Vanguard OHV V-Twin Repair Manual Page 51

  • Download
  • Add to my manuals
  • Print
  • Page
    / 85
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 50
Vanguard
TM
Twin-Cylinder OHV Liquid-Cooled Engine
Section 4 - Engine Overhaul
Page 46
3. Then, carefully drive stud and puller nut the rest of
the way through seal.
Fig. 98
4. Center the puller and stud in water pump seal and
then rotate puller and stud 90°.
5. Assemble support driver , pilot nut , washer
, and nut to puller stud and center
assembly over water pump seal.
6. Hold hex head of puller stud and tighten nut until
water pump seal is removed.
7. Thoroughly clean seal bearing surfaces.
Fig. 99
Installing Water Pump Seal
1. Press or drive in new water pump seal until it
bottoms with a 32 mm 12 point socket, Fig 100.
Fig. 100
REPLACING STARTER SOLENOID
1. Remove nut and field coil wire from stud terminal.
2. Remove solenoid mounting nuts and solenoid.
3. Lift solenoid to disengage drive lever from
plunger, Fig. 101.
NOTE: Hold starter in vertical position with drive
housing side down when removing and installing
solenoid.
Fig. 101
Page view 50
1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 84 85

Comments to this Manuals

No comments