Vanguard OHV V-Twin Repair Manual Page 39

  • Download
  • Add to my manuals
  • Print
  • Page
    / 85
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 38
Vanguard
TM
Twin-Cylinder OHV Liquid-Cooled Engine
Section 3 - Engine Disassembly
Page 34
REMOVE CAMSHAFT
1. Rotate crankshaft and camshaft until timing marks
align, then remove camshaft and tappets, Fig.
61.
Fig. 61
REMOVE PISTONS, RODS,
CRANKSHAFT
NOTE: Remove any carbon or ridge at the top of
cylinder bores to prevent breaking rings when
removing piston and connecting rod assemblies.
1. Remove No. 2 connecting rod cap and push
connecting rod and piston assembly out of
cylinder, Fig. 62.
NOTE: Reassemble cap to rod to prevent
interchanging.
2. Repeat for other cylinder.
Fig. 62
3. Remove crankshaft.
4. Remove governor shaft, Fig. 63.
Fig. 63
NOTE: Clean all surfaces of gasket material.
Remove oil seals and o-rings. Throughly clean
components in solvent. Organize components,
keeping parts which are an assembly together.
Page view 38
1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 84 85

Comments to this Manuals

No comments